Vape devices sometimes experience small problems that affect performance. These issues often have simple fixes and may not mean something is broken. With a few careful checks and some easy steps, it’s possible to bring the device back to smooth working condition. A few of these issues are:
Device not firing:
If the Myle Dubai doesn’t activate during a puff, it may be due to poor contact between the pod and device. Remove the pod, wipe the connection area with a dry cotton swab, and reinsert it gently. Ensure the pod clicks into place. If the issue continues, check if the battery is charged.
Weak vapour output:
Low vapour may happen if the battery is nearly empty or the pod is running low. Charge the device fully and try again. If the vapour is still light, switch to a new pod. Also, avoid taking sharp, fast puffs slower draws often lead to better vapour performance.
Leaking pods:
A small amount of liquid around the pod or in the device can affect performance. If leaking occurs, remove the pod and clean both the pod base and the device with tissue or cotton. Keep pods upright during storage and avoid squeezing them while in use.
Burnt taste:
A burnt taste may appear when a pod is used past its best condition. Replace the pod if it feels dry or the flavor changes suddenly. To avoid this issue, avoid chain-puffing and allow a few seconds between pulls. This gives the wick time to absorb more liquid.
Pod not detected:
Sometimes the device may not detect the pod at all. This may be due to dust or residue on the contact points. Gently clean both the pod and the device connection area. If that doesn’t work, try a different pod to check if the issue is with the pod itself.
Flashing light on the device:
A flashing light usually signals a low battery or a pod connection issue. Start by charging the device. If the light still flashes after charging, take out the pod and insert it again firmly. A proper fit often stops the blinking and gets the device ready for use again.
